Costumes and Performances by Tab Kimpton

A Tale of Two Doctors, Part 9- Shoulder pads and lining

I’m currently tailoring a jacket that isn’t going so well, so here’s a tutorial to perk me up about costumes!
DrWhoCoat216

Onward to inserting the lining!

 

DrWhoCoat203

DrWhoCoat204The easiest time to get the shoulder pads into the coat is now, so off I go! These were made with two layers of wadding and some cotton mull and tacked into place.

DrWhoCoat205

 

The coat inside out on a mannequin- notice that it still doesn’t have it’s sleeves.

DrWhoCoat206

 

I measure and cut a 4inch band of interfacing. I work in inches or cm depending on what I feel like at the time. I didn’t say I would make sense, just that I make things.

DrWhoCoat207

 

This then gets ironed down all around the hem of the coat to give it support and a crisp edge.

DrWhoCoat208

 

Mmm crisp edge…

 

DrWhoCoat164

 

The lining is a simplified version of the outer coat. I’ve condensed the skirt panels into two mains, taken out the collar facing and added a circle of facing to support the back.

DrWhoCoat209

 

I have enough of the fancy lining fabric to simplify even further so I join the top front and skirt together.

DrWhoCoat210

 

Sewing back top to bottom.

DrWhoCoat211

 

 

Adding a wavy line at the back gives it a bit more flexibility and avoids the back centre seam from fraying/popping.

DrWhoCoat212

 

A lining is done! This is what is commonly referred to as bagged lining where you make a 2 copies of the garment and one is the lining.

DrWhoCoat213

 

I pin the lining all around the back facing and front lapels.

DrWhoCoat214

DrWhoCoat215

 

This part can be sewn in by hand with a pick stitch, but you get good results with a machine still so I’m doing it that way to save time. I leave the bottom hem open because that baby needs a touch of hand sewing. Time to turn it all out the right way!

 

DrWhoCoat218

 

Next I zigzag the sleeve lining inside the sleeve. In a typical garment the sleeve is part of the lining and you secure it at the cuff but for suits I’ve always preferred having the lining supported inside the sleeve, especially with long coats. Easing sleeve allowance in regular fabric is difficult, let alone in flimsy lining fabric!

DrWhoCoat219

 

Now it’s time to begin the adventures in hand stitching! There’s a whip stitch on the main hem, though the iron on hem tape is a good substitute if you’re rushed for time, or have a life.

DrWhoCoat220

 

Everything pinned down and looking fancy.

DrWhoCoat221

 

I used a pretty herringbone stitch on the bottom hem so it can wiggle about a bit.

DrWhoCoat222

 

Up the centre of the back vent it’s a ladder stitch- this is completely invisible once it’s pulled through and I use it lots.

DrWhoCoat223

 

See- look how pretty it is!

 

 

DrWhoCoat216

DrWhoCoat217

 

Tada, the vest of the coat is now lined- tune in next time for Super Sexy Sleeve Setting!

5 Responses

Leave a Reply to Ian Michael MacPharlaine Cancel reply

Your email address will not be published.